Line Trace

Access the Trace Configuration Page

Point a browser to http://IPaddress (where 'IPaddress' is the IP address assigned to the SyncServer) and log in as User ID "admin".
From the X.25 Menu in the left-hand navigation select the link to be configured from the drop-down field.
Below the link number select Trace.
Select the Go button.

Description

The Trace feature interprets trace buffers maintained by the protocol software to display the contents of all frames exchanged with the remote on the standard output device. Frames arriving from the remote with incorrect CRC characters are not displayed.

Settings
Trace for # seconds	Define the number of seconds (from 5 to 120) that you wish the trace to run.
Trace LCI # only	Specify, by number, a single virtual circuit on this link to trace.
Display # of bytes per frame	This value is used to set the frame trace buffer sized.The maximum value is 80 bytes.
Switches
Character Decoding	Use this to decode the packet trace information from ASCII or EBCDIC to plain text.
Decode Facilities	Starts a symbolic display of packet level facilities.
Decode Packet Level	Starts a symbolic display of packet level data.
Show Time Stamps	Prints the time of the frames arrival in the first column of the symbolic display.
Show Frame Level RRs	Turns on Frame level RR tracing.
Raw Trace	Will display raw data. Protocol headers will not be interpreted.